Linksys RTP300 User Guide - Page 111
Off Hook Warning Tone, MWI Dial Tone
UPC - 745883565658
View all Linksys RTP300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Regional page Off Hook Warning Tone Played when the caller has not properly placed the handset on the cradle. Off Hook Warning Tone is played when Reorder Tone times out. The default is 480@10,620@0;10(.125/.125/1+2). Ring Back Tone Played during an outbound call when the far end is ringing. The default is 440@-19,480@-19;*(2/4/1+2). Ring Back 2 Tone Your ATA device plays this ringback tone instead of Ring Back Tone if the called party replies with a SIP 182 response without SDP to its outbound INVITE request. The default value is the same as Ring Back Tone, except the cadence is 1s on and 1s off. The default is 440@-19,480@-19;*(1/1/1+2). Confirm Tone Brief tone to notify the user that the last input value has been accepted. The default is 600@-16; 1(.25/.25/1). SIT1 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/ 3,0/4/0). SIT2 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/ 3,0/4/0). SIT3 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/ 3,0/4/0). SIT4 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an outbound call. The RSC to trigger this tone is configurable on the SIP screen. The default is 985@-16,1371@-16,1777@-16;20(.380/0/1,.274/0/2,.380/0/ 3,0/4/0). MWI Dial Tone Played instead of the Dial Tone when there are unheard messages in the caller's mailbox. The default is 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2). Cfwd Dial Tone Played when all calls are forwarded. The default is 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2). Holding Tone Informs the local caller that the far end has placed the call on hold. The default is 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1). Conference Tone Played to all parties when a three-way conference call is in progress. The default is 350@-19;20(.1/.1/1,.1/9.7/1). Secure Call Indication Tone Played when a call has been successfully switched to secure mode. It should be played only for a short while (less than 30 seconds) and at a reduced level (less than -19 dBm) so it does not interfere with the conversation. The default is 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2). Linksys ATA Administration Guide 111