Linksys RTP300 User Guide - Page 158
Speed Dial Settings Supplementary Service Settings - wireless
UPC - 745883565658
View all Linksys RTP300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
User page Voice tab > User page > Speed Dial Settings section This section does not apply to the WIP310 wireless phone. Field Speed Dial 2-9 Description Target phone number (or URL) assigned to speed dial 2, 3, 4, 5, 6, 7, 8, or 9. The default is blank. Voice tab > User page > Supplementary Service Settings section The ATA device provides native support of a large set of enhanced or supplementary services. All of these services are optional. The parameters listed in the following table are used to enable or disable a specific supplementary service. A supplementary service should be disabled if a) the user has not subscribed for it, or b) the Service Provider intends to support similar service using other means than relying on the ATA device. Field CW Setting Block CID Setting Block ANC Setting DND Setting CID Setting CWCID Setting Dist Ring Setting Secure Call Setting Message Waiting Description Call Waiting on/off for all calls. The default is yes. Block Caller ID on/off for all calls. The default is no. Block Anonymous Calls on or off. The default is no. DND on or off. The default is no. Caller ID Generation on or off. The default is yes. Call Waiting Caller ID Generation on or off. The default is yes. Distinctive Ring on or off. The default is yes. If yes, all outbound calls are secure calls by default. The default is no. This value is updated when there is voice mail notification received by the ATA device. The user can also manually modify it to clear or set the flag. Setting this value to yes can activate stutter tone and VMWI signal. This parameter is stored in long term memory and will survive after reboot or power cycle. The default is no. Linksys ATA Administration Guide 158