Linksys RTP300 User Guide - Page 67
Configuring a Trunk Group, Voice tab > L
UPC - 745883565658
View all Linksys RTP300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
SIP Trunking and Hunt Groups on the SPA8000 NOTE: The Trunk UA will also apply the Trunk Dial Plan on the number before sending out INVITE to the ITSP. This Trunk Dial Plan typically is redundant since the trunk should trust the number sent by the Line UA. By default the trunk dial plan allows any non-empty number: ([*#0-9A-D][*#0-9A-D].) Configuring a Trunk Group To configure a hunt group, you must first specify the trunk lines by assigning lines to trunk groups. Then you enter the account information, specify the call capacity, and configure the Contact List. Before you begin this procedure, determine which lines you want to associate with each trunk group that you are configuring. Refer to the following example: Line 1, 3, 5 4, 6, 8 2 Trunk Group T1 T2 None 1. Connect to the administration web server, and choose Admin access with Advanced settings. 2. Assign each line to a trunk group, as needed: a. Click Voice tab > Ln, where n represents the number of the line interface. b. In the Trunk Group field, near the top of the line configuration page, choose a trunk number or choose none for a standalone line (the default setting). c. Repeat this step for each line that you want to add to a trunk group. Voice > Ln > Trunk Group field Linksys ATA Administration Guide 67