Maytag MGDZ400TQ Use and Care Guide - Page 23
See Venting
UPC - 883049064963
View all Maytag MGDZ400TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
4. Close the door. 5. Press the POWER button. 6. Select a Timed Dry Cycle and temperature (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Fluff temperature setting. 7. You may change the cycle time by pressing Timed Dry Cycle Adjust Up or Down arrow buttons, Reset time as needed to complete drying. Refer to the following table. 8. Press (and hold) START button (about 3 seconds/. This chart shows examples of items that can be rack dried and the suggested temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold. Rack Dry Wool Sweaters Block to shape and lay flat on the rack. Stuffed toys or pillows Cotton or polyester fiber filled Stuffed toys or pillows Foam rubber filled Setting limed Dry Cycles Timed Dry Cycles Timed Dry Cycles Sneakers or canvas shoes Timed Dry Cycles *(Minutes) Reset time to complete drying, if needed. Temp. Low kow Air Fluff (no heat) Air Fluff (no heat) Time* 60 60 90 90 [.{Ka[ Kee l) dryer area clear and free from items that would obstruct the flow of combustion and ventilation air. To clean 1. Pull the lint screen straight up. Roll lint off the screen with your fingers. 19o not rinse or wash screen to remove lint Wet lint is hard to remove. Explosion Hazard Keep flammable materials and vapors, gasoline, away from dryer. such as Place dryer at least 18 inches (46 era) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. Every load cleaning The lint screen is located increase drying time. in the door opening of the dryer. A screen blocked by lint can 2. Push the lint screen firmly back into place. IMPORTANT: • Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics. • if lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See "Venting Requirements." As needed cleaning kaundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off the screen. Clean the lint screen with a nylon brush every 6 months, or more frequently, clogged due to a residue buildup. To wash if it becomes I. Roll lint off the screen with your fingers. 2. Wet both sides of lint screen with hot water.