Pioneer AVHP7800DVD Owner's Manual - Page 124

Troubleshooting, Additional Information

Get Pioneer AVHP7800DVD - DVD Player / LCD Monitor PDF manuals and user guides
UPC - 012562799179
View all Pioneer AVHP7800DVD manuals
Add to My Manuals
Save this manual to your list of manuals

Page 124 highlights

Appendix Additional Information Troubleshooting Common Symptom Cause Action (See) Power doesn't turn on. The unit doesn't operate. Leads and connectors are incorrectly connected. Confirm once more that all connections are correct. The fuse is blown. Rectify the reason for the fuse blowing, then replace the fuse. Be very sure to install the correct fuse with the same rating. Noise and other factors are causing Press RESET. (Page 15) the built-in microprocessor to operate incorrectly. Operation with the remote con- The remote control operation mode trol isn't possible. is incorrect. The unit does not operate cor- The remote control code is incorrectly even when the appropriate rect. remote control buttons are pressed. Battery power is low. Switch to the correct remote control mode. (Page 21) Make sure the remote control selection switch setting and code type setting are the same. (Page 115) Load new battery. (Page 16) Some operations are prohibited with certain discs. Check by using another disc. Playback is not possible. The disc is dirty. Clean disc. (Page 128) The loaded disc is a type this unit Check what type the disc is. cannot play. Non compatible video system disc Change to a disc compatible to your video is loaded. system. No sounds are heard. The volume level will not rise. Cables are not connected correctly. Connect the cables correctly. The unit is performing still, slow mo- There is no sound during still, slow motion or tion or frame-by-frame playback. frame-by-frame playback. The front, rear, left and right speak- Adjust the relative levels between the speakers are not properly adjusted in level ers correctly. (Page 92) balance. Sound is not heard over a speci- The speaker size is set to OFF. fic speaker. Make the correct size setting for the speaker. (Page 101) The speaker level is set too low. Increase the speaker level setting to get the balance right with the other speakers. (Page 104) The center speaker size is set to Set the center speaker size to OFF. (Page 101) SMALL or LARGE whereas no cen- ter speaker is installed. There is no picture. The parking brake cord is not con- Connect a parking brake cord, and apply the nected. parking brake. The parking brake is not applied. Connect a parking brake cord, and apply the parking brake. 124 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
Troubleshooting
Common
Symptom
Cause
Action (See)
Power doesn
’
t turn on.
The unit doesn
’
t operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that all connections are
correct.
The fuse is blown.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rating.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
Press
RESET
. (Page 15)
Operation with the remote con-
trol isn
’
t possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
The remote control operation mode
is incorrect.
Switch to the correct remote control mode.
(Page 21)
The remote control code is incor-
rect.
Make sure the remote control selection
switch setting and code type setting are the
same. (Page 115)
Battery power is low.
Load new battery. (Page 16)
Some operations are prohibited
with certain discs.
Check by using another disc.
Playback is not possible.
The disc is dirty.
Clean disc. (Page 128)
The loaded disc is a type this unit
cannot play.
Check what type the disc is.
Non compatible video system disc
is loaded.
Change to a disc compatible to your video
system.
No sounds are heard.
The volume level will not rise.
Cables are not connected correctly.
Connect the cables correctly.
The unit is performing still, slow mo-
tion or frame-by-frame playback.
There is no sound during still, slow motion or
frame-by-frame playback.
The front, rear, left and right speak-
ers are not properly adjusted in level
balance.
Adjust the relative levels between the speak-
ers correctly. (Page 92)
Sound is not heard over a speci-
fic speaker.
The speaker size is set to
OFF
.
Make the correct size setting for the speaker.
(Page 101)
The speaker level is set too low.
Increase the speaker level setting to get the
balance right with the other speakers. (Page
104)
The center speaker size is set to
SMALL
or
LARGE
whereas no cen-
ter speaker is installed.
Set the center speaker size to
OFF
. (Page 101)
There is no picture.
The parking brake cord is not con-
nected.
Connect a parking brake cord, and apply the
parking brake.
The parking brake is not applied.
Connect a parking brake cord, and apply the
parking brake.
Additional Information
En
124
Appendix