Pioneer SC-55 Owner's Manual - Page 66

10 Controlling the rest of your system 5 Repeat steps 3 to 4 to program a sequence of up to five commands. If you press RCU SETUP before programming is completed, commands programmed up to that point will be stored. 6 Press RCU SETUP to exit the programming mode. Using multi operations 1 Press MULTI OPERATION. Release the button after the LED flashes once. The LED continues to flash. 2 Within five seconds, press an input function button that has been set up with a multi operation. The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically. Using System off 1 Press MULTI OPERATION. Release the button after the LED flashes once. The LED continues to flash. 2 Within five seconds, press u SOURCE. The command sequence you programmed will run, then all Pioneer components will switch off, followed by this receiver (switch of all the zones becomes off). ! In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent. Erasing the settings for the multi-operation This erases all the settings programmed in the remote control for the multi-operation. 1 Press and hold RCU SETUP, then press '8' for three seconds. Release the button after the LED flashes once. The LED continues to flash. 66 En ! To cancel the preset setup mode press RCU SETUP. 2 Press the input function button containing the program you want to cancel or the u SOURCE button for three seconds. If the LED lights for one second, the erasing has been successfully completed. Resetting the remote control settings Use this procedure to reset all the remote control's settings to the factory default. ! When preset codes are set, all the signals learned in the input function buttons are cleared. This function is convenient when you want to reset some but not all of input function buttons. 1 Press and hold RCU SETUP, then press '0' for three seconds. Release the button after the LED flashes once. The LED continues to flash. 2 Press and hold the ENTER button for three seconds. If the LED lights for one second, the erasing has been successfully completed. Default preset codes Input function button DVD BD DVR/BDR HDMI TV/SAT CD TV CTRL Preset code 2158 2160 2150 2159 0116 5066 0116 Controlling components This remote control can control components after entering the proper codes (see Setting the remote to control other components on page 63 for more on this). Use the input function buttons to select the component. ! The TV CONTROL buttons on the remote control are dedicated to control the TV assigned to the TV CTRL button. If you have two TVs, assign the main TV to the TV CTRL button. RECEIVER MULTI OPERATION SOURCE RCU SETUP BDR BD DVD DVR HDMI SAT TV CD HMG ADPT USB iPod OPTION TUNER SIRIUS INPUT SELECT TV CTRL RECEIVER INPUT MASTER VOLUME TV CONTROL CH VOL MUTE AUDIO PARAMETER LIST VIDEO PARAMETER TUNE TOOLS TOP MENU BAND T.EDIT GUIDE PRESET ENTER PRESET CATEGORY RETURN HOME MENU TUNE iPod CTRL AUTO/ALC/ PGM MEMORY MENU DIRECT STEREO STANDARD ADV SURR HDD DVD THX PHASE CTRL STATUS TV / DTV MPX PQLS HDMI OUT 1 2 3 AUDIO SIGNAL SEL MCACC SLEEP INFO 4 5 6 DISP CH LEVEL A.ATT DIMMER 7 8 9 D.ACCESS / CLR 0 CLASS CH ENTER ZONE 2 ZONE 3 LIGHT RECEIVER