Home » Sony Manuals » Voice Recorders » Sony HDWD1800 » Manual Viewer

Sony HDWD1800 Operation Manual - Page 32

Cassettes - hdw d1800 manual

Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Chapter 3 Preparations 3-5 Cassettes 3-5-1 Cassette Types This unit uses the following HDCAM cassettes for both recording and playback. HDCAM cassettes Small cassettes Large cassettes BCT-6HD/12HD/22HD/32HD/40HD BCT-34HDL/64HDL/94HDL/124HDL The HDW-D1800 can also play back the following cassettes. • Digital Betacam cassettes • MPEG IMX cassettes 3-5-2 Inserting and Ejecting Cassettes It is not possible to insert or eject a cassette unless the unit is powered on. To insert a cassette EJECT button 1 2 Small cassette To remove slack from the tape Press in one of the reels with a finger, and turn gently in the direction shown by the arrows until there is no slack in the tape. To eject a cassette Press the EJECT button. Note Ejecting is a local operation. It is not possible to eject a cassette in another VTR by remote control. If the tape slacks inside the unit, pressing the EJECT button may not eject the cassette. For information about how to remove the cassette in such a case, refer to the Installation Manual. 3-5-3 Preventing Accidental Erasure of Recordings To prevent a tape from being inadvertently erased, press in the record inhibit plug on the cassette. Large cassette STANDBY REW PLAY F FWD STOP Large cassette STANDBY button STOP button 1 Turn the POWER switch on. 2 Check the following points, then insert the cassette horizontally in the orientation shown in the figure. • Check that message "ERR-10" is not shown in the time data/menu display section. • Check that there is no slack in the tape. The cassette is drawn into the unit, and the STANDBY and STOP buttons light. Small cassette Press in the record inhibit plug. (ON) Return this plug to its original position to enable recording on the tape again. (OFF) 32 3-5 Cassettes

Section	Page
Table of Contents	4
Chapter 1 Overview	6
1-1 Features	6
1-2 Example System Configuration	9
1-3 Description of the Function Menu in this Manual	10
Chapter 2 Location and Function of Parts	11
2-1 Control Panels	11
2-1-1 Upper Control Panel	12
2-1-2 Lower Control Panel	13
2-1-3 Switch Panel	22
2-2 Connector Panel	23
Chapter 3 Preparations	27
3-1 Connections to External Devices	27
3-1-1 Connections to Digital Devices	27
3-2 Reference Sync Signals	28
3-2-1 Selecting Reference Sync Signal Depending on Operational Status	28
3-2-2 Connecting Reference Signals	28
3-3 Setup	29
3-4 Superimposed Character Information	30
3-5 Cassettes	32
3-5-1 Cassette Types	32
3-5-2 Inserting and Ejecting Cassettes	32
3-5-3 Preventing Accidental Erasure of Recordings	32
Chapter 4 Recording and Playback	33
4-1 Recording	33
4-1-1 Preparations for Recording	33
4-1-2 Recording Timecode and User Bit Values	34
4-1-3 Recording Procedure	36
4-2 Playback	37
4-2-1 Preparations for Playback	37
4-2-2 Playback Procedures	37
4-2-3 DMC (Dynamic Motion Control) Playback	40
Chapter 5 Editing	43
5-1 Automatic Editing	43
5-1-1 Overview	43
5-1-2 Switch Settings	44
5-1-3 Selecting the Editing Mode	45
5-1-4 Setting Edit Points	45
5-1-5 Modifying and Deleting Edit Points	47
5-1-6 Cuing up to Edit Points and Preroll	48
5-1-7 Preview	48
5-1-8 Carrying Out Automatic Editing	49
5-2 DMC Editing	51
5-2-1 Overview	51
5-2-2 Carrying Out DMC Editing	51
5-3 Special Automatic Editing Methods	53
5-3-1 Quick Editing	53
5-3-2 Continuous Editing	53
5-3-3 Standalone Editing	53
5-3-4 Preread Editing	54
Chapter 6 Shot Mark Function	55
6-1 Overview	55
6-2 Shot Mark Operations	56
6-2-1 Reading Shot Marks	56
6-2-2 Writing Shot Marks	56
6-2-3 Shot Mark List Operations	57
6-2-4 Cuing Up to Shot Marks	59
Chapter 7 UMID Functions	60
7-1 Overview	60
7-2 Recording UMIDs	60
7-3 UMID Output and Display	62
7-3-1 UMID Output Settings	62
7-3-2 UMID Display	62
Chapter 8 Function Menu	64
8-1 Overview	64
8-1-1 Function Menu Configuration	64
8-1-2 Function Menu Operations	64
8-2 Function Menu Item List	65
8-2-1 User-Definable Function Menu Pages (P01 to P10)	65
8-2-2 Non-User-Definable Function Menu Pages (P100 to P118)	69
Chapter 9 Setup Menus	74
9-1 Setup Menu Configuration	74
9-2 Setup Menu Operations	75
9-3 Items in the Basic Setup Menu	78
9-4 Items in the Extended Setup Menu	81
Chapter 10 Maintenance and Inspection	103
10-1 Removing a Cassette when Tape Slack Occurs	103
10-2 Head Cleaning	103
10-3 Error Messages	104
10-4 Moisture Condensation	106
10-5 Regular Checks	106
10-5-1 Digital Hours Meter	106
10-5-2 Maintenance Timings	107
10-6 About the LCD	108
Appendix	109
Specifications	109
About a “Memory Stick”	116