Sony HDWD1800 Operation Manual - Page 99
MOMNT, LATCH, MODE1, MODE2, Item number, Item name, Settings
View all Sony HDWD1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Chapter 9 Setup Menus Menu items in the range 900 to 999, relating to digital processing (Continued) Item number Item name Settings 904 FREEZE CONTROL Select how the buttons used to freeze an image function. FROM KEY PANEL MOMNT: Select F8 (FREEZE) in function menu page P05: MISC-2 carries out a freeze. The freeze ends when the button is released. LATCH: Select the F8 (FREEZE) carries out a freeze. The freeze continues even after the button is released. • To update the freeze image Select F8 (FREEZE) again. • To end the freeze Select F9 (FREZ OFF). 905 AUTO FREEZE CONTROL Set the auto freeze function operation (conditions for cancelling a freeze, etc.). In dynamic tracking (DT) playback (VAR, JOG, PLAY or SHTL mode), if there is a sudden worsening of the channel condition (entry into unrecorded area), this function detects the sudden worsening and freezes the image. DIS: Disable the auto freeze function. MODE1: Automatically cancel the freeze when signals which can be normally played back are restored. MODE2: Automatically cancel the freeze upon start of playback after stopping. • The automatic freeze mode is set by menu item 903. • The freeze is ended immediately, regardless of the above settings, when this unit is switched to any of the following modes: Edit preset function on Cue up Recording 906 STOP FREEZE CONTROL Select whether the STOP FREEZE function should operate. DIS: Do not operate. ENA: Operate. stby: Operate only in standby mode. 918 a) SLOW PROCESS MODE (enabled only when the optional HKDW-104 board is installed) Select whether to increase the vertical resolution during slow playback by activating the relevant filter. OFF: Do not increase the vertical resolution during slow playback. ON: Increase the vertical resolution during slow playback. 920 SD-SDI H-ANC CONTROL Select whether to add information to the SD output. (Invalid in 24PsF or 23.98PsF mode) Sub-item 1 AUDIO 5CH-8CH ON: Add digital audio data CH5 to CH8. OFF: Do not add digital audio data CH5 to CH8. 2 RP188 ATC ON: Add RP188 timecode data. OFF: Do not add RP188 timecode data. 921 ASPECT FLAG Select whether to add the 16:9/Squeeze ID signal provided for by ARIB TR-B17 to (Invalid in 50i, 25PsF, the down-converted SD output when an HDCAM tape is played back. Also select 24PsF or 23.98PsF mode) whether to switch the upconverter mode when a 16:9/Squeeze ID signal is detected on an SD playback tape. OFF: Do not add the 16:9/Squeeze ID signal to the SD signal down-converted from HD. When an SD tape is played back, the upconverter mode follows setup menu item 950 regardless of detection of the ID signal on the tape. ON: Add the 16:9/Squeeze ID signal to SD output down-converted from HD in Squeeze mode. When an SD tape is played back, automatically switch the upconverter mode change by detecting the ID signal on the tape. If the 16:9/Squeeze ID signal is not detected on the SD tape, the upconverter mode follows setup menu item 950. 99 9-4 Items in the Extended Setup Menu