Sony HDWD1800 Operation Manual - Page 63

UMID INFORMATION INSTANCE 24PRS XX-XX-XX 1 MATERIAL SMPTE 2 XX-XX-XX-XX-XX-XX-XX-XX XX-XX-XX-XX-XX-XX-XX-XX 3 DATE/TIME 20XX/XX/XX XX:XX:XX:XX +XX:XX 4 ALTITUDE XXXXXXXXm 5 LONGITUDE EXXX XX'XX.XX 6 LATITUDE SXXX XX'XX.XX 7 ORGANIZATION XXXX 8 USER XXXX COUNTRY XXXX 9 a Instance Number generation method and Instance Number The generation method is displayed as follows. CP+16: "16-bit PRS (pseudo-random sequence) + Copy No." method 24PRS: 24-bit PRS method others: Other than the above When menu item 656 "MATERIAL NO." is set to "NEW", it is generated by SMPTE method. b Material Number generation method SMPTE: SMPTE method IEEE 1394 ZONE: IEEE 1394 ZONE method IEEE 1394 RND: IEEE 1394 RND method others: Other than the above c Material Number The material number is displayed in hexadecimal in two lines. The following items, 4 to 9, are contained in the Source Pack. d Date/Time Date/Time data is displayed in two lines. The upper line shows the MJD (Modified Julian Date) contained in the Source Pack converted to UTC. The lower line shows the data in unit count format (hours : minutes : seconds : frame) converted to UTC. recording device (Recorder), and "T" is shown for Target position data. • "+" (2nd character): Indicates higher than sea level. "-" indicates lower than sea level. • "XXXXXXXm" : Altitude data (unit: meter). • "Y": The number of satellites used to calculate position data (hexadecimal). • "D": DOP (dilution of precision) value. • "+" (between Y and D): Displayed when a supportive geodetic apparatus was used. A space (blank) is displayed when no supportive geodetic apparatus was used. f Longitude Following "W" to indicate west longitude or "E" to indicate east longitude, the longitude is displayed in degrees, minutes, and seconds (seconds are displayed up to 2 decimal places). Example: "E134 59'23.00" for "East longitude 134 degrees 59 minutes 23.00 seconds" g Latitude Following "N" to indicate north latitude or "S" to indicate south latitude, the latitude is displayed in degrees, minutes, and seconds (seconds are displayed up to 2 decimal places). Example: "N34 59'23.32" for "North latitude 34 degrees 59 minutes 23.32 seconds" Note The function for converting unit count to UTC works only when the unit rate is 2 (24 frames), 3 (24/1.001 frames), 4 (25 frames), 6 (30 frames), or 7 (30/1.001 frames). For other unit rates, the unit rate number and unit rate are displayed in hexadecimal. e Altitude XXXXXXXXm: Altitude data indicating the distance from the center of the earth is displayed in this format. S+XXXXXXXm Y+D: Altitude data indicating the distance from sea level is displayed in this format. The meaning of the characters and strings shown is as follows. • "S" (1st character): Indicates position data from a Sensor. "R" is shown for position data from the Chapter 7 UMID Functions 63 7-3 UMID Output and Display