Sony HDWD1800 Operation Manual - Page 65
Function Menu Item
View all Sony HDWD1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
When a menu item setting flashes You can change the setting value by turning the MULTI CONTROL knob. To change the function menu page Press one of the menu page selection buttons (P1 to P5) to change the function menu page to the corresponding page. By default the following pages are assigned to the menu page selection buttons. • P1: Changes the function menu page to P01: HOME. • P2: Changes the function menu page to P02: TC. • P3: Changes the function menu page to P03: VID PROC. • P4: Changes the function menu page to P08: AUD INP. • P5: PAGE DOWN Each time the menu page selection button P5: PAGE DOWN is pressed, the function menu page changes in the order P01 t P02 t P03 t P04 t P05 t P06 t P07 t P08 t P01. When this button is pressed with the SHIFT/ENTRY button held down, the function menu page changes in the reverse order. All of the function buttons in function menu pages P09 and P10 are undefined when the unit is shipped from the factory. If you try to display a page with no function assigned using the P5: PAGE DOWN, the target page is skipped to change to the next displayable function menu page. For example, in the factory default configuration described above, the display order is "P08 t P01". Settings which do not appear in the menu display In function menu page P01: HOME (see the figure in Section "8-1-1 Function Menu Configuration"), the settings for F9 (MENU) and F10 (TCG SET) do not appear in the lower part of the function button display area. When you press the F9 or F10 button, the function menu page changes to allow you to set the menu items for F9 or F10, respectively. For more information about changing (user-defining) the functions of function buttons and menu page selection buttons and the settings of user-definable function menu pages, refer to the Maintenance Manual Volume 1. 8-2 Function Menu Item List The function menu has the following items. 8-2-1 User-Definable Function Menu Pages (P01 to P10) Functions on these function menu pages can be changed to user-defined functions. Standard functions are already set on the eight function menu pages P01 to P08, when the unit is shipped from the factory. The function menu pages and function buttons are provided with the functions by factory default as follows. Note The explanations in this manual are based on the factory default standard settings. P01: HOME This is a function menu page for setting basic items. Item Setting F1 (VIDEO IN) Selects the input video signal. SDI: HDSDI signal SG (normally not displayed): Test signal from the internal test signal generator (For details, see setup menu item 710 on page 94.) To change to SG, hold down the ALT/ DELETE button, then select F1. F2 (No function assigned) F3 (EDIT) Jump to P06: EDIT (editing control page). F4 Jump to P07: E.PRESET (edit preset page). (E.PRESET) F5 (CLR CNT) Tape counter clear F6 (PB/EE) Select the video and audio signals output during fast forward, rewind, stop, and standby. PB: Playback signals EE: E-E mode signals F7 (CONFI) Select whether or not to use the CONFI playback function when recording. a) ENABLE: Use the CONFI playback function. DISABL: Do not use the CONFI playback function. Chapter 8 Function Menu 65 8-2 Function Menu Item List