Sony HT-8800DP Operating Instructions (RDR-GX300 DVD Recorder) - Page 20
Step 5: Connecting the Power Cord, Step 6: Preparing the Remote
View all Sony HT-8800DP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Step 5: Connecting the Power Cord Step 6: Preparing the Remote Connect the supplied power cord to the AC IN terminal of the recorder. Then plug the recorder and TV power cords into an AC outlet. After you connect the power cord, you must wait for a short while before operating the recorder. You can operate the recorder only after the front panel display lights up and the recorder enters standby mode. If you connect additional equipment to this recorder (page 29), be sure to connect the power cord only after all connections are complete. You can control the recorder using the supplied remote. Insert two size AA (R6) batteries by matching the 3 and # ends on the batteries to the markings inside the battery compartment. When using the remote, point it at the remote sensor on the recorder. ~ AC IN 1 to AC IN 2 to AC outlet Notes • If the supplied remote interferes your other Sony DVD recorder or player, change the command mode number for this recorder (page 22). • Use the batteries correctly to avoid possible leakage and corrosion. Do not touch the liquid with bare hands should leakage occur. Observe the following: - Do not use a new battery with an old battery, or batteries of different manufacturers. - Do not attempt to recharge the batteries. - If you do not intend to use the remote for an extended period of time, remove the batteries. - If battery leakage occurs, wipe out any liquid inside the battery compartment, and insert new batteries. • Do not expose the remote sensor (marked on the front panel) to strong light, such as direct sunlight or lighting apparatus. The recorder may not respond to the remote. 20