Sony HT-8800DP Operating Instructions (RDR-GX300 DVD Recorder) - Page 85
Display, Remote control, Others, OPEN/CLOSE.
View all Sony HT-8800DP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Additional Information Timer recording is not complete or did not start from the beginning. , There was a power failure during recording. If the power recovers when there is a timer recording, the recorder resumes recording. Should the power failure continue for more than 1 hour, reset the clock (page 72). , The timer setting overlapped another setting that was set later or has priority (page 46). , Disc space was not enough. Contents previously recorded were erased. , Data that has been recorded on a DVD with a PC will be erased from the disc when the disc is inserted. Display The clock has stopped. , Set the clock again (page 72). , The clock stopped due to a power failure that lasted for more than 1 hour. Reset the clock (page 72). The TIMER REC indicator is flashing. , The disc does not have enough space. , Insert a recordable disc inside the recorder. The recording mode indication is incorrect. , When the recording or dubbing is less than three minutes, the recording mode indication may be displayed incorrectly. The actual recording itself is correctly made in the selected recording mode. The clock does not appear in the front panel display. , "Dimmer" in Options Setup is set to "Power Save" (page 80). Remote control The remote does not function. , Batteries are weak. , The remote is too far from the recorder. , The remote's manufacturer code returned to the default setting when you replaced the batteries. Reset the code (page 20). , Turn on the recorder. , The remote is not pointed at the remote sensor on the recorder. , Different command modes are set for the recorder and remote. Set the same command mode (page 22). , Set the TV/DVD switch to DVD (page 21). Other Sony equipment responds to the remote. , The same command mode is set for both the equipment and recorder. Set a different command mode for the recorder (page 22). Others The recorder does not operate properly. , Restart the recorder. Press down "/1 on the recorder for more than ten seconds until "WELCOME" appears in the front panel display. , When static electricity, etc., causes the recorder to operate abnormally, turn off the recorder and wait until the clock appears in the front panel display. Then, unplug the recorder and after leaving it off for a while, plug it in again. Five numbers or letters are displayed on the front panel display. , The self-diagnosis function was activated (see the table on page 86). The disc tray does not open after you press Z OPEN/CLOSE. , It may take a few seconds for the disc tray to open after you have recorded or edited a disc. This is because the recorder is adding disc data to the disc. The disc tray does not open and "TRAY LOCKED" appears on the front panel display. , Contact your Sony dealer or local authorized Sony service facility. ,continued 85