Yamaha DTX-MULTI Owner's Manual - Page 102

TRIGGER Setting Area (TRG) TRG2-1-4 Velocity Range page TRG2-1-4≥-MID-˛¸ Velocity=≥≥0-127 1 1 Velocity Use these parameters to specify the maximum and minimum velocities corresponding to the settings made on the Input Level Range page (TRG2-1-3). When struck, the selected pad(s) will produce sounds within this velocity range. Settings Minimum velocity: 0 to 126 Maximum velocity: 1 to 127 TRG2-1-5 Double Trigger Prevention page When a stick or beater strikes a pad, it may rebound and strike again, producing a second trigger signal and causing a voice to sound twice. The term "double trigger" is used to refer to this phenomenon. A reject-time setting is used to prevent double triggers from occurring, and the DTX-MULTI 12 will reject any second input signals produced during this time period. TRG2-1-5≥-MID-˛¸ RejectTime=500ms 1 1 Reject time Use this parameter to specify the time period after a pad is struck during which a second input signal will be ignored. The larger the value set here, the longer the period during which a second sound will not be produced. Settings 4ms to 500ms NOTE • Double triggers may not be rejected in cases where the pad-type selection on the Pad Type page (TRG2-1) is other than a DT-series pad and the input level of the second strike within the reject time is at least twice that of the first strike. TRG2-2 Crosstalk Prevention page The term "crosstalk" refers to the output of trigger signals from a pad other than the one that was stuck as a result of vibration or interference between pads. From the Crosstalk Prevention page, you can set input levels below which trigger signals will not be produced, thus preventing crosstalk. With this page displayed, press the [ENTER] button to access the Global Crosstalk Level page (TRG2-2-1) and the Individual Crosstalk Level page (TRG2-2-2). You can switch between these parameter-setting pages using the [B]/[C] buttons. TRG2-2 Crosstalk NOTE • The input level indicator shown on the upper row of text on the crosstalk level pages (TRG2-2-1, TRG2-2-2) is identical to that from the Pad Type page (TRG2-1). Accordingly, it is not covered in the following page descriptions. TRG2-2-1 Global Crosstalk Level page 1 TRG2-2-1 Level=≥25%(ALL) 2 1 Pad Use this parameter to select the pad(s) for which a crosstalk level is to be set. You can also strike a pad to select it. Settings UP, MID, LOW, or 01 to 17 NOTE • Selection by striking is limited to pad groups (i.e., UP, MID, or LOW) and the external pads (i.e., 13 to 17). B Crosstalk level Use this parameter to specify a level for preventing crosstalk from all of the DTX-MULTI 12's other pads. If the input level produced at the pad indicated by 1 is lower than this level whenever any of the other pads are struck, it will be treated as crosstalk and no trigger signal will be generated. Although higher setting values are more effective in preventing crosstalk, they can also make it difficult to play multiple pads at the same time. Settings 0% to 99% 102 Owner's Manual