Yamaha DTX-MULTI Owner's Manual - Page 94

UTILITY Setting Area (UTIL) 4 When you have set a file name, press the [ENTER] button. You will be asked to confirm that the data is to be saved. To proceed, press the [ENTER] button. Alternatively, you can press the [EXIT] button to return to Step 3 above without saving. ≥≥≥Save≥File ≥Are≥you≥sure? If a file of the same name already exists, you will be asked to confirm whether it is to be overwritten as shown below. If you want to set a different file name to avoid overwriting, press the [EXIT] button to return to the Name page (UTIL7-1-2). ≥≥≥Save≥File ≥≥≥Overwrite? 5 Press the [ENTER] button to save the file. The following message will be displayed as the data is being saved. If you press the [EXIT] button at this time, the save process will be aborted and the display will return to the Name page (UTIL7-1-2). ≥Now≥saving... [EXIT]≥to≥cancel CAUTION • Do not unplug the USB memory device from the USB TO DEVICE port or turn off either the memory device or the DTXMULTI 12 while data is being saved. Failure to observe this precaution can lead to the memory device or the DTX-MULTI 12 being permanently damaged. When the file has been saved, the display will return to the Save File page (UTIL7-1). UTIL7-1≥≥≥ ≥≥≥Save≥File UTIL7-2 Load File page UTIL7-2≥≥≥ ≥≥≥Load≥File From the Load File page, you can load files previously saved on a USB memory device into the DTX-MULTI 12. 1 Plug the USB memory device containing the required files into the USB TO DEVICE port on the side of the DTX-MULTI 12. 2 Navigate to the Load File page (UTIL7-2) and press the [ENTER] button. The Type page (UTIL7-2-1) will open. UTIL7-2-1≥ Type=All File type The Type parameter specifies the types of file to be loaded. • All All user data - i.e., all User kits, all waves, all User patterns, all User triggers, and utility settings. • AllKit .......... All User-kit data • Kit A single User kit • AllWave....... All wave data • Wave A single wave • AllPattern .... All User-pattern data • Pattern ......... A single User pattern • AllTrigger.... All User-trigger data • Trigger......... A single User trigger setup • Utility .......... Utility settings Settings All, AllKit, Kit, AllWave, Wave, AllPattern, Pattern, AllTrigger, Trigger, or Utility 3 Specify a file type using the Type parameter, and press the [ENTER] button. The File page (UTIL7-2-2) will open. UTIL7-2-2≥ ≥File=ALL_DATA File name Select the file to be loaded using the [-/DEC] and [+/INC] buttons. Only those files matching your selection on the Type page (UTIL7-2-1) will be presented for loading. If you are loading a single file, you will first of all need to select the All file that contains it (for example, when loading a single drum kit, you first select a file saved with the type "AllKit"). It is not, however, possible to load a single file when an All type has been selected for loading. 94 Owner's Manual