Yamaha DTX-MULTI Owner's Manual - Page 88

UTILITY Setting Area (UTIL) UTIL4 PAD Pad Utilities UTIL4 PAD In the PAD section, you can assign functions to pads and external controllers, specify the type of controller connected via the FOOT SW jack, and enable or disable rim pads 10 to 12. With the PAD page (UTIL4) displayed, press the [ENTER] button to access its three parameter-setting pages (UTIL4-1 to UTIL4-3). You can use the [B]/[C] buttons to navigate between these pages. UTIL4-1 Pad Function page On the Pad Function page, you can specify operations to be performed when individual pads or external controllers are struck or operated. UTIL4-1≥-º¡- 1 Func=clickOn/Off 2 1 Pad number Use this parameter to select the pad or external controller to be set. You can also strike a pad to select it. Settings 01 to 12, 13, 13R1, 13R2, 14 to 17, FTSW (foot switch), HHCL (hi-hat close), or HHSP (hi-hat splash) B Pad function (Func) Use this parameter to set the operation to be performed when the pad or external controller indicated by 1 is struck or operated. • off Voices will be played in the normal way. • inc kitNo The kit number will be increased by 1. • dec kitNo The kit number will be decreased by 1. • inc ptnNo The pattern number will be increased by 1. • dec ptnNo The pattern number will be decreased by 1. • inc tempo The tempo will be increased by 1 bpm. • dec tempo The tempo will be decreased by 1 bpm. • tap tempo The pad or external controller can be used to tap the tempo. • clickOn/Off......... The click track will be turned on or off. • CC01 to CC95 .... A MIDI Control Change message will be sent to the internal tone generator and connected external MIDI devices. Settings off, inc kitNo, dec kitNo, inc ptnNo, dec ptnNo, inc tempo, dec tempo, tap tempo, clickOn/Off, or CC01 to CC95 When a MIDI Control Change message (CC01 to CC95) is specified as the pad function, control-change values and the MIDI send channel are set as follows. If setting a pad or external controller other than "FTSW": UTIL4-1 4 Func=CC01/127 2 3 If setting "FTSW" and "ftSw" is selected on the Foot Switch Input page (UTIL4-2): UTIL4-1 4 Func=CC01/≥0-127 2 3-a 3-b If setting "FTSW" and "ftSw" is not selected on the Foot Switch Input page (UTIL4-2): UTIL4-1 4 Func=CC01 2 C Control change value Use this parameter to set a value for the MIDI control-change message indicated by 2. • If setting a pad or external controller other than "FTSW": This value will be sent when the pad or external controller is struck or operated. • If setting "FTSW" and "ftSw" is selected on the Foot Switch Input page (UTIL4-2): 3-a is the value that will be sent when the foot switch is released, and 3-b is the value that will be sent when the foot switch is depressed. • If setting "FTSW" and "ftSw" is not selected on the Foot Switch Input page (UTIL4-2): A specific control- change value cannot be specified in this case. Instead, a value within the range 0 to 127 will be sent based on the degree by which the hi-hat controller or foot controller is operated. Settings 0 to 127 D Control-change send channel Use this parameter to set a MIDI channel for sending the MIDI Control Change message indicated by 2. Settings 1 to 16 88 Owner's Manual