Yamaha DTX-MULTI Owner's Manual - Page 45

Reference KIT VOICE Basic Operations ■ Navigating between Pages Each section contains a number of parameter setting pages that are used to make actual settings. With a section page displayed, press the lit [ENTER] button to access its parameter setting pages. (In certain cases, it may not be possible to access parameter-setting pages from a section page, and the [ENTER] button will not light up.) Each parameter-setting page is identified at the left of the upper row of text using the name (or abbreviation) of the setting area, the section number, and the page number (with hyphens between the numbers). You can use the [B]/[C] buttons to navigate between parameter setting pages. Example: VOICE setting area's TONE section (VCE3) VCE3 TONE [ENTER] [EXIT] Page number VCE3-1 Attack=+≥0 VCE3-2 Decay=+≥0 ■ Changing Parameter Settings By pressing the [-/DEC] or [+/INC] button, you can increase or decrease the setting of the currently selected parameter. NOTE • A setting can be decreased in units of 10 by holding down the [SHIFT] but- ton and pressing the [-/DEC] button or by holding down the [-/DEC] button and pressing the [+/INC] button. • Similarly, it can be increased in units of 10 by holding down the [SHIFT] button and pressing the [+/INC] button or by holding down the [+/INC] button and pressing the [-/DEC] button. ■ Storing Parameter Settings Whenever parameter settings have been changed on section and/or parameter-setting pages, the [STORE] button will light up to remind you to store your settings. The correct way to store parameter settings is as follows. 1 When you have finished setting parameters in a specific setting area, press the [STORE] button to open the Store Kit page. KIT≥Store≥to U001:User≥Kit Destination for stored data. VCE3-3 Release=+≥0 VCE3-4 Fc=+≥0≥≥Q=+≥0 In certain cases, a number of additional pages may be accessed from a parameter setting page using the [ENTER] button, which will light up whenever this is possible. By pressing the [EXIT] button, you can move back towards the top of the current setting area. 2 Using the [-/DEC] and [+/INC] buttons, indicate where you want your data to be stored. NOTE • The above step is not required when storing settings in the UTILITY setting area. 3 Press the [ENTER] button. You will be asked to confirm that you wish to proceed. If necessary, you can press the [EXIT] button to return to the previous page without storing any data. ≥≥≥KIT≥Store ≥Are≥you≥sure? ■ Moving the Cursor Whenever a page contains a number of different parameters, you can move the flashing cursor left and right using the [B]/[C] buttons or between the upper and lower rows of text using the [D] button. In this way, you can select the parameter setting to be changed (as described below). If there are no additional parameters to the left or right on the current page when you press the [B]/[C] button, the cursor will jump to the next parameter-setting page to the left or right, respectively. In addition, the [B]/[C] and [D] buttons will light up whenever they can be pressed to move to a different parameter on the current page or an adjacent page. 4 Press the [ENTER] button to store your data in the DTXMULTI 12's internal memory. CAUTION • If you turn off the instrument without storing modified settings, these modifications will lost (i.e., the settings will revert to their previous state when the instrument is next turned on). MIDI WAVE PATTERN UTILITY TRIGGER Owner's Manual 45