ZyXEL G-220F User Guide - Page 50
Access Point Mode Configuration, 4.1.1 Additional Setup Requirements, 4.2 The Link Info Screen
View all ZyXEL G-220F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
ZyXEL G-220F User's Guide CHAPTER 4 Access Point Mode Configuration This chapter shows you how to configure your ZyXEL G-220F in access point mode. 4.1 Access Point Mode Introduction To set your ZyXEL G-220F as an Access Point (AP), refer to Section 1.7.1 on page 23. In access point mode, your ZyXEL G-220F functions as an access point. This allows you to set up your wireless networks without using a dedicated AP device. Up to 16 wireless stations can associate to the ZyXEL G-220F. 4.1.1 Additional Setup Requirements To bridge your wired and wireless network using the ZyXEL G-220F, the following requirements must be met: 1 The ZyXEL G-220F must be installed on a computer connected to the wired network. 2 Either configure network sharing (refer to Appendix B on page 64 for an example) or bridge the two interfaces (wireless and wired) on the computer. 3 Set the wireless station's IP address to be in the same subnet as the computer in which the ZyXEL G-220F is installed. Refer to Appendix F on page 90. 4.2 The Link Info Screen Select the AP Mode radio button and wait for about five seconds to display the screen as shown. Chapter 4 Access Point Mode Configuration 50