2014 Chevrolet Spark EV Owner Manual - Page 104

5-4 Instruments and Controls If the windshield wiper lever is then moved to off before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield. If the ignition is turned to LOCK/ OFF while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield. INT (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then turn the x INT band up for more frequent wipes or down for less frequent wipes. OFF: Use to turn the wipers off. { Warning In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision. 8 (Mist): For a single wipe, briefly move the wiper lever down. For several wipes, hold the wiper lever down. Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Replace damaged wiper blades. See Wiper Blade Replacement on page 10-14. Heavy snow or ice can overload the wiper motor. A circuit breaker will stop the motor until it cools down. Wiper Parking If the ignition is turned to LOCK/ OFF while the wipers are on LO, HI, or INT, they will immediately stop. Windshield Washer Pull the windshield wiper lever toward you to spray windshield washer fluid and activate the wipers. The wipers will continue until the lever is released or the maximum wash time is reached. When the windshield wiper lever is released, additional wipes may occur depending on how long the windshield washer had been activated. See Washer Fluid on page 10-9 for information on filling the windshield washer fluid reservoir. Rear Window Wiper/ Washer If equipped with the rear wiper/ washer, the controls are on the end of the windshield wiper lever. Turn the rear wiper/washer band to operate the rear window wiper/ washer. ON: Turns the rear wiper on for continuous wipes.