2014 Chevrolet Spark EV Owner Manual - Page 89
2014 Chevrolet Spark EV Manual
Page 89 highlights
Seats and Restraints 1.1. Find the lower anchors for the desired seating position. 1.2. Put the child restraint on the seat. For rear outboard seating positions, if the head restraint interferes with the proper installation of the child restraint, the head restraint may be removed. See "Head Restraint Removal and Reinstallation" at the end of this section. When installing a rear-facing child restraint, it may be necessary to move the front seat forward to properly install the child restraint per the child restraint manufacturer instructions. See Seat Adjustment on page 3-3. 1.3. Attach and tighten the lower attachments on the child restraint to the lower anchors. 2. If the child restraint manufacturer recommends that the top tether be attached, attach and tighten the top tether to the top tether anchor, if equipped. Refer to the child restraint instructions and the following steps: 2.1. Find the top tether anchor. 2.2. Remove the cargo cover before installing the top tether. Place the cargo cover on the floor of the cargo area. The cargo cover should remain off while the top tether is in use. 3-41 2.3. Route, attach, and tighten the top tether according to your child restraint instructions and the following instructions: If you are using a single tether in an outboard seating position and the head restraint has been removed, route the tether over the seatback.