2014 Chevrolet Spark EV Owner Manual - Page 35
2014 Chevrolet Spark EV Manual
Page 35 highlights
Keys, Doors, and Windows 5. Remove the transmitter from the transmitter pocket and press K. To program additional transmitters, repeat Steps 3-5. When all additional transmitters are programmed, press and hold the O POWER button for 12 seconds to exit programming mode. Replace the plastic trim piece from the small storage area. Programming without a Recognized Transmitter Program a new key to the vehicle when a recognized key is not available. Canadian regulations require that owners see their dealer. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all of the transmitters you wish to program must be with you. 1. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT. 2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press the O POWER button. The DIC displays will again show REMOTE LEARN PENDING, PLEASE WAIT. 2-5 3. Repeat Step 2 two additional times. After the third time all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1. 4. Remove the rubber cap on the steering column. Press the button on the recognized