2014 Chevrolet Spark EV Owner Manual - Page 273
2014 Chevrolet Spark EV Manual
Page 273 highlights
Vehicle Care If the TPMS is not functioning properly, it cannot detect or signal a low tire condition. See your dealer for service if the TPMS malfunction light comes on and stays on. There are two minutes to match the first tire/wheel position, and five minutes overall to match all four tire/wheel positions. If it takes longer, the matching process stops and must be restarted. The TPMS sensor matching process is: 1. Set the parking brake. 2. Put the vehicle in ON/RUN and place the vehicle in P (Park). 3. If the DIC display is minimized, press the SELECT knob to maximize it. 4. Use the SELECT knob to scroll to the Tire Pressure display screen. 5. Press and hold the SELECT knob for five seconds to begin the sensor matching process. A message displays confirming to begin the process. 10-37 6. Use the SELECT knob to select YES with the highlighted selection, and press the SELECT knob again to confirm the selection. The horn sounds twice to signal the receiver is in relearn mode and the TIRE LEARNING ACTIVE message displays on the DIC screen. 7. Start with the driver side front tire. 8. Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position. 9. Proceed to the passenger side front tire, and repeat the procedure in Step 8. 10. Proceed to the passenger side rear tire, and repeat the procedure in Step 8. TPMS Sensor Matching Process Each TPMS sensor has a unique identification code. The identification code needs to be matched to a new tire/wheel position after rotating the tires or replacing one or more of the TPMS sensors. The TPMS sensor matching process should also be performed after replacing a spare tire with a road tire containing the TPMS sensor. The malfunction light should go off at the next ignition cycle. The sensors are matched to the tire/wheel positions, using a TPMS relearn tool, in the following order: driver side front tire, passenger side front tire, passenger side rear tire, and driver side rear. See your dealer for service or to purchase a relearn tool.