2014 Chevrolet Spark EV Owner Manual - Page 215
2014 Chevrolet Spark EV Manual
Page 215 highlights
Driving and Operating will release the parking brake. If the Y switch is held in the up position until the vehicle comes to a stop, the EPB will remain applied. If the Electric Parking Brake light flashes continuously, the EPB is only partially applied or released, or there is a problem with the EPB. The DIC message SERVICE PARKING BRAKE will be displayed. If this light flashes continuously, release the EPB, and attempt to apply it again. If this light continues to flash, do not drive the vehicle. See your dealer. If the Service Electric Parking Brake light is on, the EPB has detected a system problem and is operating with reduced functionality. To apply the EPB when this light is on, lift up on the Y switch and hold it in the up position. Full application of the parking brake by the EPB system may take a longer period of time than normal when this light is on. Continue to hold the Y switch until the Electric Parking Brake light remains on. If the Service Electric Parking Brake light is on, see your dealer. If the EPB fails to apply, the rear wheels should be blocked to prevent vehicle movement. For maximum EPB force when parking on a hill, pull the EPB switch twice. The vehicle may automatically apply the EPB in some situations when the vehicle is not moving. This is normal, and is done to periodically check the correct operation of the EPB system. 9-23 displayed. The EPB is released when the Electric Parking Brake light is off. If the Service Electric Parking Brake light is on, the EPB has detected a system problem, and is operating with reduced functionality. To release the EPB when this light is on, push down on the Y switch and hold it in the down position. EPB release may take a longer period of time than normal when this light is on. Continue to hold the Y switch until the Electric Parking Brake Light is off. If the light is on, see your dealer. EPB Release To release the EPB, place the vehicle in ON/RUN, apply and hold the brake pedal, and push down momentarily on the Y switch. If attempting to release the EPB without the brake pedal applied, a chime will sound, and the DIC message STEP ON BRAKE TO RELEASE PARK BRAKE will be { Caution Driving with the parking brake on can overheat the brake system and cause premature wear or damage to brake system parts. Make sure that the parking brake is fully released and the brake system warning light is off before driving.