2014 Chevrolet Spark EV Owner Manual - Page 287
2014 Chevrolet Spark EV Manual
Page 287 highlights
Vehicle Care 13. Unplug the power plug (9) from the accessory power outlet in the vehicle. 14. Turn the sealant/air hose (2) counterclockwise to remove it from the tire valve stem. 15. Replace the tire valve stem cap. 16. Remove the tire sealant canister (4) from the slot on top of the compressor (6). 17. Turn the air only hose (10) counterclockwise to remove it from the tire sealant canister inlet valve (1). 18. Turn the sealant/air hose (2) clockwise onto the sealant canister inlet valve (1) to prevent sealant leakage. 19. Return the air only hose (10) and power plug (9) back to their original storage location. 20. If the flat tire was able to inflate to the recommended inflation pressure, remove the maximum speed label from the sealant canister and place it in a highly visible location. Do not exceed the speed on this label until the damaged tire is repaired or replaced. 21. Return the equipment to its original storage location in the vehicle. 22. Immediately drive the vehicle 8 km (5 mi) to distribute the sealant in the tire. 10-51 23. Stop at a safe location and check the tire pressure. Refer to Steps 1-10 under "Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)." If the tire pressure has fallen more than 68 kPa (10 psi) below the recommended inflation pressure, stop driving the vehicle. The tire is too severely damaged and the tire sealant cannot seal the tire. See Roadside Assistance Program on page 13-5. If the tire pressure has not dropped more than 68 kPa (10 psi) from the recommended inflation pressure, inflate the tire to the recommended inflation pressure.