2014 Chevrolet Spark EV Owner Manual - Page 221
2014 Chevrolet Spark EV Manual
Page 221 highlights
Driving and Operating Reducing Speed While Using Cruise Control If the cruise control system is already activated: . 9-29 Using Cruise Control on Hills How well cruise control works on hills depends on the vehicle speed, load, and the steepness of the hills. When going up steep hills, you might have to step on the accelerator pedal to maintain the vehicle speed. When going downhill, you might have to brake or shift to a lower gear to maintain the vehicle speed. When the brakes are applied, cruise control is disengaged. Ending Cruise Control There are three ways to end cruise control: ... Driver Assistance Systems Rear Vision Camera (RVC) The vehicle may have an RVC system. Read this entire section before using it. The RVC system can assist the driver when backing up by displaying a view of the area behind the vehicle. Press and hold the SET/− until the lower desired speed is reached, then release it. To slow down in small increments, briefly press the SET/− button. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) slower. . Passing Another Vehicle While Using Cruise Control Use the accelerator pedal to increase the vehicle speed. When you take your foot off the pedal, the vehicle will slow down to the previous set cruise speed. While pressing the accelerator pedal or shortly following the release to override cruise control, briefly pressing the SET/- button will result in cruise control set to the current vehicle speed. { Warning The RVC system does not display children, pedestrians, bicyclists, animals, or any other object located outside the camera's field of view, below the bumper, or under the vehicle. Perceived distances may be different from actual distances. Do not back the vehicle using only the RVC (Continued) Step lightly on the brake pedal. Press *. To turn off the cruise control, press I. Erasing Speed Memory The cruise control set speed is erased from memory by pressing I or if the vehicle is turned off.