2014 Chevrolet Spark EV Owner Manual - Page 22

1-16 In Brief time may be lengthened. When a full charge is desired, the charging time will be increased. The charging system may run fans and pumps that result in sounds from the vehicle while it is turned off. Additionally, clicking sounds may be caused by the electrical devices used while charging. While the charge cord is plugged into the vehicle, the vehicle cannot be driven. AC Charging Start Charge 1. Make sure the vehicle is parked and turned off. 2. Push m on the charge port door in and release to open the door. In cold weather conditions, ice may form around the charge port door. The charge port door may not open on the first attempt. Remove ice from the area and repeat attempting to open the charge port door. 3. Open the rear hatch, lift the load support floor covering, and remove the charge cord. It is located near the tire sealant and compressor kit. Pull up on the charge cord handle to release it from the handle clip. Lift the charge cord up and rearward to remove it from the vehicle. The vehicle plug is stored as shown. 4. Plug the charge cord into the electrical outlet. See Electrical Requirements for Battery Charging on page 9-41. Verify the charge cord status. See the charge cord user guide and