3Com 2928 User Guide - Page 154

Return to SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list. SNMP Configuration Example Network requirements z As shown in Figure 1-17, the NMS connects to the agent, Switch, through an Ethernet. z The IP address of the NMS is 1.1.1.2/24. z The IP address of the VLAN interface on Switch is 1.1.1.1/24. z The NMS monitors the agent using SNMPv3. The agent reports errors or faults to the NMS. The NMS uses port 5000 to receive traps. Figure 1-17 Network diagram for SNMP configuration Configuration procedure 1) Configure Agent # Configuration IP addresses for the interfaces. (Omitted) # Enable SNMP. Select Device > SNMP from the navigation tree, and you will enter the Setup page as shown in Figure 1-18. Figure 1-18 Enable SNMP z Select the Enable radio box. z Select the v3 radio box. z Click Apply. # Configure an SNMP view. z Click the View tab and then click Add to enter the page as shown in Figure 1-19. 1-13