Adaptec 3200S User Guide - Page 73
The following buttons are available, SCSI only, Adaptec RAID Installation Guide
UPC - 760884136430
View all Adaptec 3200S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Storage Manager The following buttons are available: Test Alarm (SCSI only) Flash Caching Defaults Cancel SCSI ID (SCSI only) SCSI TERMPWR (SCSI only) Transfer (SCSI only) Termination (SCSI only) Address, IRQ Tests the audible alarm on the controller. Displays the Flash Configuration window to update the controller firmware and BIOS. Selects the controller cache parameters. Resets the controller configuration to factory default settings. Cancels any changes you have made and returns to the Host Bus Adapter Info window. Your controllers is set to ID 7 by default. Refer to the Adaptec RAID Installation Guide for more information about selecting an alternate SCSI ID. By default, SCSI RAID controllers supply termination power through the TERMPWR line on the SCSI cable. This setting does not normally need to be changed. The maximum possible transfer rate. The controller automatically negotiates with each device at powerup, or reset, to determine the maximum transfer rate. This parameter should only be changed when troubleshooting SCSI bus errors. If data errors are eliminated by setting the value to a lower rate, there might be problems with the length of the bus or the bus termination. This parameter sets SCSI termination for the controller. The default value (Auto) should not be changed unless both internal and external cables are attached to the controller or you are using an 8-bit (Narrow) cable. Refer to the Adaptec RAID Installation Guide for information about configuring SCSI bus termination. These fields display the controller memory address and IRQ value assigned by the host BIOS. These values cannot be changed. 3-28