Asus AP1720-E1 User Guide - Page 38

Installing into a bay on the second drive cage

Get Asus AP1720-E1 PDF manuals and user guides View all Asus AP1720-E1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

7. Connect the IDE and power cables to their corresponding connectors on the back of the drive. 8. Follow steps 2 to 6 if you wish to install other hard disk drives. 9. Re-install the front panel assembly when done. Installing into a bay on the second drive cage To install an internal drive : 1. Remove the side cover. Refer to section 2.1.1 for instructions. 2. Use a Phillips (cross) screwdriver to attach Rail 2 to the side of the drive with two screws as shown. The rail handle should be on the side of the drive connectors. Hole 4 Hole 2 Rail handle Drive connectors 3. Attach Rail 1 to the side of the drive with two screws as shown. The rail handle should be on the side of the drive connectors. Hole 2 Hole 4 Rail handle Drive connectors 2-22 Chapter 2: Hardware setup

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
Chapter 2:
Hardware setup
2-22
Installing into a bay on the second drive cage
To install an internal drive :
1.
Remove the side cover. Refer to section 2.1.1 for instructions.
2.
Use a Phillips (cross) screwdriver to attach
Rail 2
to the side of the
drive with two screws as shown. The rail handle should be on the side
of the drive connectors.
Drive connectors
Hole 2
Hole 4
Rail handle
Drive connectors
Hole 2
Hole 4
Rail handle
3.
Attach
Rail 1
to the side of the drive with two screws as shown. The
rail handle should be on the side of the drive connectors.
7.
Connect the IDE and power
cables to their corresponding
connectors on the back of the
drive.
8.
Follow steps 2 to 6 if you wish to
install other hard disk drives.
9.
Re-install the front panel
assembly when done.