Asus Adaptec 2020 ZCR User Manual - Page 40
Installing the Windows Driver, Installing the Driver When You Install Windows
View all Asus Adaptec 2020 ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Installing the Driver 4 Click Create Driver Disk, then select the appropriate operating system. 5 If you selected Linux, you must also select the architecture: - i386-For Intel 386 or 486 computers - i586-For Pentium I or II computers - i686-For Pentium III, IV, or AMD K-6 computers - Athlon-AMD Athlon computers 6 Select the appropriate floppy drive letter, then choose the appropriate format. You need a full format only if the disk has never been formatted or may have bad sectors. 7 Insert a floppy disk, then click OK. The system creates the driver disk. 8 Remove and label the driver disk. Now that you have created your driver disk, identify the appropriate driver installation procedure and proceed with the installation. Installing the Windows Driver This section contains the following procedures: ■ Installing the Driver When You Install Windows ■ Installing the Driver in an Existing Windows System Installing the Driver When You Install Windows To install the driver while also installing the Windows operating system, follow these steps: 1 Install and configure the controller and hard drives, as described in page 2-3. 2 Create the bootable array, as described on page 2-5. 3 Create the driver disk, as described on page 3-2. When finished, remove the driver disk. 4 Insert the Windows setup CD and restart the computer to begin the Windows installation. 3-3