Asus Adaptec 2020 ZCR User Manual - Page 42
Installing the Linux Module, Installing the Module When You Install Red Hat
View all Asus Adaptec 2020 ZCR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Installing the Driver Installing the Linux Module This section contains the following procedures: ■ Installing the Module When You Install Red Hat ■ Installing the Module in an Existing Linux System Notes: ■ SuSE Linux only-The controller is not supported as a bootable controller. In other words, you can only use Installing the Module in an Existing Linux System on page 3-6. ■ For the most up-to-date information on Adaptec's support of Linux, visit www.adaptec.com. Installing the Module When You Install Red Hat To install the module with the operating system during a fresh install: 1 Install and configure the controller and hard drives, as described in page 2-3. 2 Create the bootable array, as described on page 2-5. 3 Create the driver disk, as described on page 3-2. When finished, remove the driver disk. 4 Insert the first Red Hat installation CD and restart the computer to begin the operating system installation. 5 Restart the computer. 6 When the Red Hat Welcome screen appears, type expert at the Boot: prompt. 7 When prompted, insert the driver disk, then select OK. 8 Follow the prompts to set up your preferred environment. 9 If you are installing other third-party devices, proceed with the installation of those devices. Otherwise, select Done. 10 Proceed with the Linux installation according to the Red Hat instructions. 3-5