Brother International DS-620 Users Guide - Page 41
Calibration was successful, Options, Calibration failed, to end calibration, and then click
View all Brother International DS-620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Scanner Calibration h Hold the edges of the Calibration Sheet and insert it into the feeder slot as shown below. Click Yes. 6 NOTE Hold only the edges of the Calibration Sheet and be careful not to touch the white or black area. Leaving marks or fingerprints on this sheet can cause errors in calibration. i Scanning starts automatically. j After the Calibration Sheet is scanned, a Calibration was successful message appears on your screen, indicating that calibration is finished. Click OK to end calibration, and then click OK to close the Options screen. NOTE If a Calibration failed message appears on your screen, remove the Micro USB Cable from your computer. Reconnect the Micro USB Cable to the computer and perform the calibration again. If calibration fails again, check the scanner's print head to ensure it is clean. 36