Canon REALiS WUX6000 D Pro AV User Manual - Page 156
Edge Blending with Four Projectors, Set [Marker] to [Off].
View all Canon REALiS WUX6000 D Pro AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Installation-Related Menu Settings 5 Use the remote control's [ ] button to select [Start position], and use the [ ] / [ ] buttons to move the marker to the right edge where the images overlap. 6 Use the remote control's [ ] button to select [Width], and use the [ ] / [ ] buttons to move the marker to the overlapping area. The area between the starting and ending markers is called the blending area. Brightness of this area is automatically adjusted to match the brightness of other image areas. After you complete settings for the left image, do the same thing for the right image, to specify the blending area along the left edge. Adjust the area so that the blending area for the left and right images is the same. Specifying a large blending area may cause dialog boxes for input signal selection or status to be covered by the blending area. In this case, momentarily switch edge blending from [Adjust] to [Off], check the display, and then return the setting to [Adjust]. Although the starting marker is normally aligned with the image edge, it can also be aligned more toward the center of the image. In this case, the black blending area will lie outside of the starting marker. 7 Set [Marker] to [Off]. Edge Blending with Four Projectors Images from four projectors can also be blended, as shown at left. Specify the blending area where each image overlaps with others. Example: When specifying the blending area for the lower-right image, configure the settings for blending areas along the top and left image edges. Complete the settings for the other three images the same way for the edges that overlap. 156