Canon REALiS WUX6000 D Pro AV User Manual - Page 99
Specifying Power Management Duration, Specifying Direct Power-On
View all Canon REALiS WUX6000 D Pro AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Customizing System Operation (System Settings) Specifying Power Management Duration > [System settings] > [Power management duration] HDMI Digital PC Component Analog PC LAN USB Specify how long before the lamp is turned off or the projector enters standby, depending on the [Power management mode] setting. Specifying Direct Power-On > [System settings] > [Direct power on] HDMI Digital PC Component Analog PC LAN USB You can turn on the projector by connecting the power cable without pressing the POWER button. Operation Setting Functions from Menus 5 min. 60 min. After 30 seconds without an input signal when the projector is idle, the projector starts displaying a countdown of the selected time. Once this time elapses without an input signal and while the projector remains idle, the lamp is turned off or the projector enters standby. (P98) Off You need to press the POWER button to turn on the projector. On You can turn on the projector by connecting the power cable only. Press the OK button to accept your setting and then press the MENU button. • [Off] is the factory default. Press the OK button to accept your setting and then press the MENU button. • [15 min.] is the factory default. • If conditions that would start countdown are met while you are blanking projection, blanking is canceled. • Once countdown begins, audio output stops. • Before enabling direct power on, be sure to set [Power management mode] to an option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not available. • After turning off the projector, wait at least 5 minutes before turning it on again. It may shorten the lamp life if you turn on the projector immediately after turning it off. 99