Canon XA50 XA50 XA55 Instruction Manual - Page 120

Menu Options Menu item [Speaker Volume] 120 [Monitor Channels] [HDMI Channels] [Notification Sounds] Setting options and additional information Volume adjustment bar: 0 to 15 (8), [Ø] (softer), [Ù] (louder) In mode only, this setting is an alternative way to adjust the built-in speaker's volume (A 99). [ƒ CH1/CH2], [š CH1/CH1], [Ÿ CH2/CH2], [ [ CH3/CH4], [ CH3/CH3], [ CH4/CH4], [ [ CH1+3/CH2+4] CH1+2/CH1+2], CH3+4/CH3+4], (A 110) [ƒ CH1/CH2], [ CH3/CH4] (A 111) [ High Volume], [ Low Volume], [j Off] A beep will accompany some of the camcorder's operations. • While pre-recording is activated, the camcorder will not emit any notification sounds. [£ Display Setup] menu Menu item u [Output Terminal] [HDMI Max Resolution] u [SDI Output] u [3G-SDI Mapping] u [SDI/HDMI Scan Mode] v [HDMI Scan Mode] [Output Status] [LCD Brightness] [LCD Backlight] [Viewfinder Backlight] [LCD Mirror Image] [Output Onscreen Displays] [Onscreen Markers] Setting options and additional information [ø SDI], [ù HDMI] [3840x2160]*, [1920x1080], [1280x720(59.94P)] * Available only in mode. [1920x1080], [1280x720(59.94P)] [ Level A], [ Level B] [ P], [ PsF (Forced 1080i)] (A 107, 108) (A 108) (A 107) (A 107) (A 109) - Displays a screen where you can check the configuration (video and audio) of the output signal. Brightness adjustment bar, [ ] (darker), [ ] (brighter) • Changing the brightness of the screen does not affect the brightness of your recordings or the brightness of the playback image on a TV. [ Bright], [ Normal], [ Dim] [ Bright], [ Normal] Changes the screen's backlight level to one of three levels (LCD screen) or two levels (viewfinder), affecting the general brightness of the screen. • Changing the brightness of the screen does not affect the brightness of your recordings or the brightness of the playback image on a TV. [i On], [j Off] When this setting is set to [i On], this function reverses the image on the screen horizontally when you rotate the LCD panel 180 degrees toward the subject. In other words, the screen will show a mirror image of the subject. • If the camcorder is operated (touch screen, physical buttons and switches, or remote operation) while the mirror image is displayed, the normal image will be displayed temporarily. After about 4 seconds, the mirror image is displayed again. [i On], [j Off] When this setting is set to [i On], the camcorder's onscreen displays will appear also on the screen of a TV or monitor connected to the camcorder. [j Off], [4 Level (Gray)], [3 Level (White)], [6 Grid (Gray)], [5 Grid (White)] You can display a grid or a horizontal line at the center of the screen. Use the markers as a reference to make sure your subject is framed correctly (vertically and/or horizontally). • Using the onscreen markers will not affect the recordings.