Cisco 4948 Installation Guide - Page 33

Chapter 2 Preparing for Installation Site Requirements • Plan for future growth. Your Catalyst 4948E or Catalyst 4948E-F switches currently installed in an enclosed or partially enclosed rack might meet ambient air temperature and air flow requirements now. However, if you add more chassis or other equipment to the rack, the additional heat generated might cause the ambient air temperature within the rack to exceed 104°F (40°C) and can cause minor alarms. • If you are installing the Catalyst 4948E-F in a data center that uses the hot isle and cold isle style of cooling, we recommend that you use an optional inlet air duct to extend the chassis air intake to the cold isle. Panduit Corporation manufactures a Modular ToR Switch Inlet Duct (Model CDE2) that can be installed along with the Catalyst 4948E-F chassis to extend the switch chassis air intake to the cold isle at the front of the rack enclosure. Humidity High-humidity conditions can cause moisture migration and penetration into the system. This moisture can cause corrosion of internal components and degradation of properties such as electrical resistance, thermal conductivity, physical strength, and size. Extreme moisture buildup inside the system can result in electrical shorts, which can cause serious damage to the system. Each system is rated to operate at 8 to 80 percent relative humidity, with a humidity gradation of 10 percent per hour. In storage, a system can withstand from 5 to 95 percent relative humidity. Buildings in which climate is controlled by air-conditioning in the warmer months and by heat during the colder months usually maintain an acceptable level of humidity for system equipment. However, if a system is located in an unusually humid location, a dehumidifier can be used to maintain the humidity within an acceptable range. Altitude Operating a system at high altitude (low pressure) reduces the efficiency of forced and convection cooling and can result in electrical problems related to arcing and corona effects. This condition can also cause sealed components with internal pressure, such as electrolytic capacitors, to fail or perform at reduced efficiency. Each system is rated to operate at altitudes from -50 to 6500 feet (-16 to 1981 meters) and can be stored at altitudes of -50 to 35,000 feet (-16 to 10,668 meters). Dust and Particulates Fans cool the power supplies and the system components by drawing in room temperature air, circulating the air through the power supplies and the chassis, and exhausting the heated air out through various openings in the chassis. However, fans also ingest dust and other particulates, causing contaminant buildup on the fan blades and in the system. This can create a thermal blanket on components increasing the internal chassis temperature. A clean operating environment can greatly reduce the negative effects of dust and other particulates. The standards listed below provide guidelines for acceptable working environments and acceptable levels of suspended particulate matter: • Network Equipment Building Systems (NEBS) GR-63-CORE • National Electrical Manufacturers Association (NEMA) Type 1 • International Electrotechnical Commission (IEC) IP-20 OL-21561-02 Catalyst 4948E and Catalyst 4948E-F Switch Installation Guide 2-5