D-Link DES-3010F Reference Manual - Page 106
show link_aggregation, config lacp_ports, Link Aggregation Algorithm = mac_source
View all D-Link DES-3010F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
DES-30XX Layer 2 Switch CLI Reference Manual show link_aggregation Purpose Used to display the current link aggregation configuration on the Switch. Syntax show link_aggregation {group_id | algorithm} Description This command will display the current link aggregation configuration of the Switch. Parameters − Specifies the group ID. The Switch allows up to 3 link aggregation groups to be configured. The group number identifies each of the groups. group_id 3 is designed for the uplink modules only (the last two ports on the Switch (9-10, 17-18, 25-26) and cannot be viewed here. algorithm − Displays the link aggregation algorithm in use on the Switch. Restrictions None. Example usage: To display Link Aggregation configuration: DES-3026:4#show link_aggregation Command: show link_aggregation Group ID : 1 Type : LACP Master Port : 5 Member Port : 5-7,9 Active Port : Status : Disabled Flooding Port : Example Usage: DES-3026:4# To display the link aggregation algorithm set on the switch. DES-3026:4#show link_aggregation algorithm Command: show link_aggregation algorithm Link Aggregation Algorithm = mac_source DES-3026:4# config lacp_ports Purpose Used to configure settings for LACP compliant ports. Syntax config lacp_ports mode [active | passive] Description This command is used to configure ports that have been previously designated as LACP ports (see create link_aggregation). Parameters − Specifies a range of ports to be configured for LACP. mode - Select the mode to determine if LACP ports will process LACP control frames. active - Active LACP ports are capable of processing and sending LACP control frames. This allows LACP compliant 102