D-Link DES-3010F Reference Manual - Page 107
config lacp_ports, show lacp_port, DES-3026:4#show lacp_port 1-11
![]() |
View all D-Link DES-3010F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
DES-30XX Layer 2 Switch CLI Reference Manual config lacp_ports devices to negotiate the aggregated link so the group may be changed dynamically as needs require. In order to utilize the ability to change an aggregated port group, that is, to add or subtract ports from the group, at least one of the participating devices must designate LACP ports as active. Both devices must support LACP. passive - LACP ports that are designated as passive cannot process LACP control frames. In order to allow the linked port group to negotiate adjustments and make changes dynamically, at one end of the connection must have "active" LACP ports (see above). Restrictions Only administrator-level users can issue this command. Example usage: To configure LACP port mode settings: DES-3026:4#config lacp_port 1-6 mode active Command: config lacp_port 1-6 mode active Success. DES-3026:4# show lacp_port Purpose Used to display current LACP port mode settings. Syntax show lacp_port {} Description This command will display the LACP mode settings as they are currently configured. Parameters - Specifies a range of ports that will be viewed. Restrictions None. Example usage: To display LACP port mode settings: DES-3026:4#show lacp_port 1-11 Command: show lacp_port 1-11 Port -----1 2 3 4 5 6 7 8 9 10 11 Activity -------Active Active Active Active Active Active Passive Passive Passive Passive Passive DES-3026:4# 103
![](/manual_guide/products/dlink-des3010f-reference-manual-19b7797/107.png)