D-Link DES-3526DC Product Manual - Page 15
Features, Rapid Spanning Tree and IEEE 802.1s Multiple
View all D-Link DES-3526DC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual This stand-alone Switch enables the network to use some of the most demanding multimedia and imaging applications concurrently with other user applications without creating bottlenecks. The built-in console interface can be used to configure the Switch's settings for priority queuing, VLANs, and port trunk groups, port monitoring, and port speed. NOTE: For the remainder of this manual, all hardware versions of the DES-3500 Series switches will be referred to as simply the Switch or the DES-3500 except where the differences are relevant. Features • IEEE 802.3 10BASE-T compliant • IEEE 802.3u 100BASE-TX compliant • IEEE 802.1p Priority Queues • IEEE 802.3x flow control in full duplex mode • IEEE 802.3ad Link Aggregation Control Protocol support. • IEEE 802.1x Port-based and MAC-based Access Control • Address table: Supports up to 8K MAC addresses per device • Supports a packet buffer of up to 3 Mbits • Supports Port-based VLAN Groups • Port Trunking with flexible load distribution and fail-over function • IGMP Snooping support • SNMP support • IEEE 802.1Q VLAN • IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid Spanning Tree and IEEE 802.1s Multiple Spanning Tree support • Access Control List (ACL) support • Single IP Management support • Access Authentication Control utilizing TACACS, XTACACS and TACACS+ • Dual Image Firmware • Simple Network Time Protocol support • MAC Notification support • Asymmetric VLAN support • System and Port Utilization support • System Log Support • Support port-based enable and disable • Secure Sockets Layer (SSL) and Secure Shell (SSH) support • Port Mirroring support • MIB support for: • RFC1213 MIB II • RFC1493 Bridge • RFC1757 RMON • RFC1643 Ether-like MIB • RFC2233 Interface MIB • Private MIB • RFC2674 for 802.1p • IEEE 802.1x MIB • RS-232 DCE console port for Switch management • Provides parallel LED display for port status such as link/act, speed, etc. • High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881 packets/sec on each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet port. • Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to simultaneously transmit and receive data. It only works with connections to full-duplex-capable end stations and switches. Connections to a hub must take place at half-duplex • Support broadcast storm filtering • Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion • Supports by-port Egress/Ingress rate control. • Supports IP-MAC Port Binding. • Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed • Supports STP Loopback Detection • Safeguard Engine Support 2