D-Link DES-3526DC Product Manual - Page 44

xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual Link Aggregation Algorithm RMON Status 802.1x Status 802.1x Authentication Protocol Asymmetric VLAN Syslog Global State The algorithm that the Switch uses to balance the load across the ports that make up the port trunk group is defined by this definition. Choose MAC Source, MAC Destination, MAC Src & Dest, IP Source, IP Destination or IP Src & Dest (See the Link Aggregation section of this manual). Remote monitoring (RMON) of the Switch is Enabled or Disabled here. MAC Address may enable by port or the Switch's 802.1x function; the default is Disabled. This field must be enabled to view and configure certain windows for 802.1x. More information regarding 802.1x, its functions and implementation can be found later in this section, under the Port Access Entity folder. Port-Based 802.1x specifies that ports configured for 802.1x are initialized based on the port number only and are subject to any authorization parameters configured. MAC-based Authorization specifies that ports configured for 802.1x are initialized based on the port number and the MAC address of the computer being authorized and are then subject to any authorization parameters configured. The user may use the pull-down menu to choose between radius eap and radius pap for the 802.1x authentication protocol on the Switch. The default setting is radius eap. This field will enable or disable Asymmetric VLANs on the Switch. The default is Disabled. Enables or disables Syslog State; default is Disabled. Click Apply to implement changes made. NOTE: When the Asymmetric VLAN function is Disabled, the user must change the VLAN setting on the Switch to its default configurations. 30