Dell 3115 Color Laser User Guide - Page 217

IPv4 Get IP Address AutoIP* Automatically sets the IP address. BOOTP Uses BOOTP to set address. RARP Uses RARP to set the IP address. P Uses DHCP to set the IP address. Panel E the IP address entered on the operator panel. IP Address Sets the IP address allocated to the printer by he keys on the operator panel. Subnet Mask Sets the subne Gateway Address Sets the gateway address. Res *2 Disables IPs *1 Only displayed tional multi-protocol card is installed on the printer. *2 Only displayed when enabled. *3 This mode is available hen firmware version 200706291103 or later and network (MPC) f version 16.03 or later are installed. Since you cannot set IPs indows Vista in this mode, use the Del Configuration Web Tool. The G mation from Printer function on the ions tab of the printer driver is not available when is mode. Protocol Purpose: To enable or disable each item. The change becomes effective after the printer i off and then on again. Values: LPD Enable* Enables the LPD port. Disable Disables the LPD port. Port9100 E E he Port9100 port. Disable Disables the Port9100 port. IPP*1 Enable* Enables the IPP port. Disable Disables the IPP port.