Dell 3115 Color Laser User Guide - Page 221
TCP/IP, Protocol, Dell Printer Confi Web Tool
![]() |
View all Dell 3115 Color Laser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
Purpose: To initialize wireless network settings. After g this function and rebooting the printer, all wireless net ettings are reset to their default values. TCP/IP Purpo To specify the TCP/IP settings for th less network. The change becomes effective after th er is turned off and then on again. Values: IP Mode*1 Dual Stack Uses both IPv4 a to set the IP address. IPv4 Mode IPv6 Mode3 es IPv4 to set the IP address. Uses IPv6 to set the IP ad IPv4 ddress AutoIP* Automatically sets the IP address. BOOTP Uses BOOTP to set the IP a RARP Uses RARP to set address. DHCP Uses DHCP to set the IP address. Panel Enables the IP address entered on the op anel. IP Address Sets the IP a llocated to the printer by using the keys on the operator panel. Subnet Mask Sets the subnet mask. Gateway Address Sets the address. Reset IPsec* Disables IPsec. * Only displayed when an optional multi-protocol card stalled on the printer. * Only displayed when IPsec is enabled. * This mode is available only when firmware versi 06291103 or later and network (MPC) firmware version 16. r are installed. Since you cannot set IPsec in Windows V this mode, use the Dell Printer Confi Web Tool. The Get Information Printer function on the Option tab of the printer driver is not available when using ode. Protocol Purpose:
![](/manual_guide/products/dell-3115-color-laser-user-guide-7889d46/221.png)