Dell Inspiron 14 5410 2-in-1 Service Manual - Page 15

Installing the base cover, Prerequisites, About this task, Steps, Next steps

Get Dell Inspiron 14 5410 2-in-1 PDF manuals and user guides View all Dell Inspiron 14 5410 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Installing the base cover Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the base cover and provide a visual representation of the installation procedure. Steps 1. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place. 2. Replace the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly. 3. Tighten the three captive screws that secure the base cover to the palm-rest and keyboard assembly. Next steps 1. Exit Service Mode. 2. Follow the procedure in After working inside your computer. Removing and installing components 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
Steps
1.
Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the
base cover into place.
2.
Replace the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
3.
Tighten the three captive screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1.
Exit
Service Mode
.
2.
Follow the procedure in
After working inside your computer
.
Removing and installing components
15