Dell Inspiron 14 5410 2-in-1 Service Manual - Page 40
Installing the display assembly
View all Dell Inspiron 14 5410 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Steps 1. Peel the tape that secures the display cable to the system board. 2. Open the latch, and disconnect the display cable from the system board. 3. Remove the display cable from the routing guide on the palm-rest and keyboard assembly. 4. Remove the four screws (M2.5x3.5) that secure the display hinges to the palm-rest and keyboard assembly. 5. Lift at an angle and slide the display assembly off the palm-rest and keyboard assembly. Installing the display assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the display assembly and provides a visual representation of the installation procedure. 40 Removing and installing components