Dell Inspiron 14 5410 2-in-1 Service Manual - Page 45

Place the touchpad bracket into the slot on the palm-rest and keyboard assembly.

Get Dell Inspiron 14 5410 2-in-1 PDF manuals and user guides View all Dell Inspiron 14 5410 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Steps 1. Lift the transparent flap and slide the touchpad into the slot on the palm-rest and keyboard assembly. 2. Lift the transparent flap and replace the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard assembly. NOTE: Ensure that the touchpad is aligned with the guides available on the palm-rest and keyboard assembly, and the gap on either sides of the touchpad is equal. NOTE: The following image shows the proper alignment of touchpad on your computer. 3. Slide the touchpad cable into the connector on the touchpad and system board and close the latch to secure the cable. 4. Place the touchpad bracket into the slot on the palm-rest and keyboard assembly. 5. Replace the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly. Next steps 1. Install the battery. 2. Install the base cover. 3. Follow the procedure in After working inside your computer. Removing and installing components 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
Steps
1.
Lift the transparent flap and slide the touchpad into the slot on the palm-rest and keyboard assembly.
2.
Lift the transparent flap and replace the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard
assembly.
NOTE:
Ensure that the touchpad is aligned with the guides available on the palm-rest and keyboard assembly, and the
gap on either sides of the touchpad is equal.
NOTE:
The following image shows the proper alignment of touchpad on your computer.
3.
Slide the touchpad cable into the connector on the touchpad and system board and close the latch to secure the cable.
4.
Place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
5.
Replace the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
Next steps
1.
Install the
battery
.
2.
Install the
base cover
.
3.
Follow the procedure in
After working inside your computer
.
Removing and installing components
45