Dell Latitude C600 Service Manual - Page 26

Removing the Display Assembly

Get Dell Latitude C600 PDF manuals and user guides View all Dell Latitude C600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

www.dell.com | support.dell.com NOTICE: Position the keyboard flex cable so it is not pinched when you replace the keyboard in the bottom case assembly. 4 Check that the keyboard is correctly installed. The keys should be flush with the left and right surfaces of the palmrest. 5 Reinstall the five M2.5 x 12-mm screws in the holes labeled "circle K." Removing the Display Assembly NOTICE: You must remove the display assembly before you remove the palmrest assembly; the display assembly hinges pass through the back of the palmrest assembly. NOTE: Always remove and replace the display panel as a complete assembly. NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries. NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer. NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure. 26 Removi ng and Replacing Parts

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
26
Removing and Replacing Parts
www.dell.com | support.dell.com
NOTICE:
Position the keyboard flex cable so it is not pinched when you
replace the keyboard in the bottom case assembly.
4
Check that the keyboard is correctly installed. The keys should be flush
with the left and right surfaces of the palmrest.
5
Reinstall the five M2.5 x 12-mm screws in the holes labeled "circle K."
Removing the Display Assembly
NOTICE:
You must remove the display assembly before you remove the
palmrest assembly; the display assembly hinges pass through the back of the
palmrest assembly.
NOTE:
Always remove and replace the display panel as a complete assembly.
NOTICE:
Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE:
Read "Preparing to Work Inside the Computer" before performing
the following procedure.