Dell Latitude C600 Service Manual - Page 30
Removing the 14.1-Inch Display Assembly Bezel
View all Dell Latitude C600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
www.dell.com | support.dell.com Removing the 14.1-Inch Display Assembly Bezel NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries. NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer. NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure. 1 Remove the hard drive. 2 Remove the display assembly. 3 Use the scribe to pry the six rubber screw covers out of the screw holes located on the bezel on the front of the display assembly. 4 Remove the six M2.5 x 5-mm screws located on the bezel on the front of the display assembly. NOTICE: To avoid damage to the bezel, do not bend the bezel while separating it from the display-assembly top cover. 5 Use a plastic scribe to carefully separate the bezel from the display-assembly top cover. Removing the 14.1-Inch Display Panel NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries. NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer. 1 Remove the hard drive. 2 Remove the display assembly. 3 Remove the display assembly bezel. 4 Remove the hinge covers. 5 Remove the two M2 x 4-mm screws on the left side of the display panel and the two M2 x 4-mm screws on the right side of the display panel. NOTE: If you have a Hitachi display panel, remove the two M2 x 4-mm screws from the center of the left side of the display panel. 30 Removi ng and Replacing Parts