Dell PowerEdge R340 EMC PowerEdge R340 Installation and Service Manual - Page 96

Removing the right control panel

Get Dell PowerEdge R340 PDF manuals and user guides View all Dell PowerEdge R340 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 96 highlights

Figure 79. Installing the left control panel Next steps 1. Follow the procedure listed in After working inside your system. Removing the right control panel Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Disconnect the control panel cable from the connector on the system board. NOTE: Observe the routing of the cable as you remove it from the system. 2. Using the appropriate screwdriver, remove the screws that secure the right control panel assembly. 3. Hold the right control panel assembly and remove it from the system. 96 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
Figure 79. Installing the left control panel
Next steps
1.
Follow the procedure listed in
After working inside your system
.
Removing the right control panel
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
Steps
1.
Disconnect the control panel cable from the connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2.
Using the appropriate screwdriver, remove the screws that secure the right control panel assembly.
3.
Hold the right control panel assembly and remove it from the system.
96
Installing and removing system components