Dell PowerEdge R340 EMC PowerEdge R340 Installation and Service Manual - Page 97

Installing the right control panel

Get Dell PowerEdge R340 PDF manuals and user guides View all Dell PowerEdge R340 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 97 highlights

Figure 80. Removing the right control panel Next steps 1. Replace the right control panel. Installing the right control panel Prerequisites 1. Follow the safety guidelines listed in Safety instructions. Steps 1. Route the control panel cable through the side wall and the guide slots in the system. NOTE: Route the cable properly to prevent the cable from being pinched or crimped. 2. Align and insert the right control panel assembly in the slot on the system. 3. Using the appropriate screwdriver, fasten the screws that secure the right control panel assembly. 4. Connect the control panel cable to the connector on the system board. Installing and removing system components 97

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
Figure 80. Removing the right control panel
Next steps
1.
Replace the right control panel
.
Installing the right control panel
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
Steps
1.
Route the control panel cable through the side wall and the guide slots in the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2.
Align and insert the right control panel assembly in the slot on the system.
3.
Using the appropriate screwdriver, fasten the screws that secure the right control panel assembly.
4.
Connect the control panel cable to the connector on the system board.
Installing and removing system components
97