Dell PowerEdge R940 EMC Installation and Service Manual - Page 121
PEM power board, Removing the PEM power board
View all Dell PowerEdge R940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Figure 71. Cable routing - Two processor system 1. system board 2. UPI cable connecting RM_UPI_A and RM_UPI_D connectors on system board 3. UPI cable connecting RM_UPI_C and RM_UPI_B connectors on system board NOTE: This is only applicable for using Intel Processor 61xx, 62xx, 81xx and 82xx series. PEM power board Removing the PEM power board Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. 3. Remove the air shroud. 4. Lift the PEM by using the PEM handle until the PEM is in an upright position. Steps Hold the PEM power board by its edges and remove the power board from the connector on the system board. Installing and removing system components 121