Dell PowerEdge R940 EMC Installation and Service Manual - Page 140
Optional IDSDM or vFlash module, Removing the MicroSD card
![]() |
View all Dell PowerEdge R940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Figure 89. Installing the storage controller card Next steps 1. Install the NDC riser. 2. Follow the procedure listed in After working inside your system on page 66. Optional IDSDM or vFlash module Removing the MicroSD card Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 65. 2. Follow the procedure listed in Before working inside your system on page 66. Steps 1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. To locate IDSDM module, see the System board jumpers and connectors section. 2. Hold the MicroSD card and remove it from the slot. NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal. 140 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r940-emc-installation-service-manual-9de4cf2/140.png)